N O R S T A R  D A T E  &  T I M E  P R O G R A M M I N G

There are a couple of different ways access the time change feature, depending on the type of system you have.  A programming template is provided below if you need it.   Just cut-out the middle areas as well as around the outside of the template.   Once cut, place the template over the top 2 rows of buttons on your 7310 or 7324 telephone (typically lines 1 and 2 on your telephone), or the 8 rows on your 7208 telephone.

After you enter programming mode, all methods are pretty much the same.

****** IMPORTANT NOTES ******
*** The 308 and 616 KSU can be programmed with any style Norstar telephone.

*** The M8x24, Compact ICS and the Modular ICS KSU must be programmed with an M7310, T7316 or a M7324 telephone. (A M7208/T7208 will not program these systems.)

Access type 1:   Press “FEATURE ** ” – TIME (8463)  or

Access type 2:   Press “FEATURE ** ” – ADMIN (23646)

Screen displays Password: then enter 23646

Display shows 1.Sys speed dial

Press Next Display shows 2. Names

Press Next Display shows 3. Time and date

Press Show Display shows Time 16:24

On the Softkey under the display it says CHANGE

If you wish to change the time, press CHANGE , if not press NEXT

Once you pressed the CHANGE button the hour displays;

If you wish to change the hour, press CHANGE , if not press NEXT

Once you pressed the CHANGE button the hour is erased allowing you to enter the new time – enter the new hour in 24 hour format, when OK press NEXT

Once you pressed the NEXT button the minutes display;

If you wish to change the minutes, press CHANGE , if not press NEXT

Once you pressed the CHANGE button the minutes are erased allowing you to enter the new time – enter the new minutes, when OK press NEXT

Follow the same procedure for changing the date!